Moldable tape that can be shaped to uneven surfaces.
Suitable for use on pipes, door plates, grooved plates, curved surfaces, etc.
the tape is shaped to the substrate with a rubber roller, or light blows with a soft rubber hammer.
Particularly suitable for machines, garden tools etc.
Grain size: Grain 60
Properties:
- PVC based netting for grain
- Pressure-sensitive high-performance acrylic adhesive with removable film (release liner)
- Low thickness of less than 1 mm (without release liner)
- Available in rolls and pre-cut strips
- Optimal installation is achieved using a rubber mallet or a hard rubber roller.
- Colours: black, yellow and yellow/black
Can be used indoors and outdoors on flat surfaces.
Super suitable for grooved, wavy and uneven surfaces.
We recommend the use of edge sealing in wetlands.
NOTE!: The glue on the tape is pressure-activated, it is recommended to install with a rubber roller so that the glue is activated and bubbles are avoided.
Our anti-slip anti-slip tape has an incredibly high quality, compared to many other variants on the market.
Roll length: 18.3 Meters
Note that the roll width can vary approx. +/- 5mm.
(contact us if you need a more precise width, or special widths)
Areas of application:
- For indoor and outdoor areas
- For medium or high traffic
- Remedies smooth, wet surfaces or surfaces soiled with oil or grease
- Especially suitable for uneven, rough or profiled areas
- Suitable for grooved, checkered and wavy surfaces
- Entrances, passages and paths
- Steps, slopes and ramps
- Machinery and vehicles
- Suitable for bending around all types of edges
Non-slip tape in rolls from 19 to 1220mm
We have non-slip tape in rolls from 19 - 1220mm.
The rolls have a length of 18.3 metres.
The large sizes are not in stock, but they can usually be obtained within a short time.
The standard sizes in millimeters are:
19, 25, 50, 75, 100, 150, 305, 610, 914, 1220
In addition, the tape can also be obtained in special sizes.
Contact us to find out more about your options.
Non-slip tape in pre-cut sheets.
All our non-slip tape variants can be supplied in pre-cut sheets in 7 different standard sizes. If the desired variant is not on the page, contact us by email or telephone.
The 7 standard sizes are as follows: 25x800mm, 25x1000mm, 50x650mm, 50x800mm, 50x1000mm, 140x140mm, 150x610mm.
Non-slip tape cut according to your CAD drawing.
Do you have a special task that requires non-slip tape on special dimensions? We are ready to help you get your tape with exactly the measurements you need.
We can also help you prepare a CAD drawing.
Tape to special measurements can be produced from 1 pc.
Recommended products
- Ved at foretag et valg vil siden reloade
- Brug piletasterne samt mellemrumstasten for at befærde dig